black 68-pin Magma cable + CardBus card, model CBH1F with Volcano logo: $125
black 68-pin Magma cable + CardBus card, model CBH1F 01-04551-02: $150
Magma CB1H chassis with power supply, mint condition: $150
100% feedback rating up on Ebay (wmvonbrock). All prices include ground shipping within the continental US
PayPal/postal money orders or trade for/towards the following:
used Magma EC34 or EC54 (expresscard)
used/new Barber Electronics BarbEQ guitar pedal (for experimentation with Scope)
also, a used Magma PCI-E 68-pin host card
Best regards,
cap
(Note: these were used to evaulate various Scope boards, along with a couple other chassis, and they work fine. TI CardBus chipset is a must for best performance! My notebook has a crappy Ricoh CardBus slot - Magma says to avoid them at all costs )
Edit: up on Ebay
Last edited by capacitor on Sun Feb 15, 2009 11:08 pm, edited 3 times in total.
The first action people should take is to remove cash from Banrural, and break the banks of corrupt people. #escandalogt
I am interested into the ability to run scope on a laptop but I have not researched this much. Is there 3 completes setups here? What is the difference between them?
So I need the cb1h and 1 cardbus + cable to run one half-height card, right?
I have 2-pulsar 1, 1-pulsar 2 and a 15-dsp scope card. I know the scope card won't fit. But aren't the pulsars too large also?
A scope home card I know will fit.
However, for multi-card setups a larger box is a must. Also, the CB1F will fit a PII, 15-DSP card etc.
The CB1H would also be great for starting to play with those cheap UAD-1 cards, now that the UAD-2 line has been released.
The 2-card units actually will fit 3 full length cards with a bit of faux i/o plate fabrication. Unsure about cooling. The 4-card units look like the bomb for a 3 card setup, plenty of space & cooling.
The first action people should take is to remove cash from Banrural, and break the banks of corrupt people. #escandalogt
How much for the BarBQ pedal?
If you have it set up on ebay that's fine w/ me also.
That little unit does wonders to clean signals.
I saw them at clubs everywhere in Philly and NYC, but no so much out here?
Yup (we traded PMs already & sounds like he's busy with Film & Production training too)
I'm thinking it would be a great as a moderate boost & tone shaper, before an A/D stage. It is getting lots of good reviews.
(BTW - Neutron, thanks for releasing the open sdk devs! I hope to get started with them & the sdk once S/C gets the requisite paperwork. That is a very cool thing, and like someone else posted, Creamware should have had that kind of thing already in the sdk. Looking forward to it )
Edit: up on Ebay
The first action people should take is to remove cash from Banrural, and break the banks of corrupt people. #escandalogt
)
