it happens two time that vdat load the tapes but there is no output...
and nothing at the meter´s...
i can go to the marked points, vdat "remember" this.
i use the same samplerate and these things.
these are very important recordings
(i think first time that happen after i defrag my partitions/hdd with "o&o defrag"-)
the tapes and the system now are on new hdd´s.
the problem was also befor i switched to bigger hdd´s.
I read here in the forum to re-install scope on the same directory.
but that isnt possible...
vdat sounds realy better than everything that goes through asio-
so but i´m afraid to use it because maybe its going lost...
many many thanks to an answer for help!
(sorry for my bad english)
