Recording setup (VST32 vs. Pulsar II)

Flimsy · Post by **Flimsy** » Sat Apr 14, 2001 1:17 pm

Hi!
I just finished setting up VST32 and the Pulsar II on my Mac G4 Dual 450 (everything runs through my Yamaha 03D mixer). My old songs work fine already - with audio, midi and everything - and I have even managed to setup a variety of Pulsar-synths. Everything is great, except!: I simply cannot figure out (my technical skills are.....well, unfortunately almost non-existent) how to setup Pulsar, so I can record new vocals/guitar/whatever. Can anyone please guide me and help me make the proper ASIO/input/output-connections in Pulsar? I guess it is fairly simple for an experienced user. Thanx in advance

AudioIrony · Post by **AudioIrony** » Sat Apr 14, 2001 4:52 pm

I have a crude setup that I use... Pulsar is so flexable there are many ways you can do it..... but here is what I did.
For vocals/guitar, I use the analog inputs which I run into the mixer . From the mixer, I just use the analog outs to monitor...and bypass the ASIO destination so I can still hear all my tracks without having to mute them to stop them being recorded along with the new track.
I have a project file called "Recording" that I can send you if you like. (need your email address)
All the best
Brett

<font size=-1>[ This Message was edited by: blgrace on 2001-04-14 17:54 ]</font>

Flimsy · Post by **Flimsy** » Sat Apr 14, 2001 5:00 pm

Hi Brett!

Thank you! I would be so happy, if you could ship me that "recording file": fkj@post8.tele.dk

Best regards
Flimsy