Found the problem

mausmuso · Post by **mausmuso** » Tue Jan 08, 2008 10:36 pm

Hi there,
I got Reaper working.
It was pretty obvious but there ya go.
I had not unclicked the "Allow projects to override device sample rate" on the bottom of the Audio Devices page.
Of course SCOPE must set the samplerate and (in my case at least) any request by Reaper to do so made Reaper crash.
Hope this helps any one trying to get things up and running.
Regards
mausmuso

Post by **garyb** » Tue Jan 08, 2008 10:44 pm

Shroomz~> · Post by **Shroomz~>** » Wed Jan 09, 2008 6:02 am

Tips & tricks forum? Just kidding mausmuso.

Glad you figured it out.

the19thbear · Post by **the19thbear** » Thu Jan 10, 2008 3:28 am

do you use reaper in xtc mode??? i cant get it working!
When it detects the scope plugins, the blue "choose scope hardware" ( the one where you have to improt keys etc..) box pops up.. but for somew weird reason there is no hardware to choose! so.. according to reaper i have no scope card when i use xtc mode!?

it works fine in sfp mode.
thanks alot!

alfonso · Post by **alfonso** » Thu Jan 10, 2008 5:10 am

the19thbear wrote:do you use reaper in xtc mode??? i cant get it working!
When it detects the scope plugins, the blue "choose scope hardware" ( the one where you have to improt keys etc..) box pops up.. but for somew weird reason there is no hardware to choose! so.. according to reaper i have no scope card when i use xtc mode!?

it works fine in sfp mode.
thanks alot!

I don't use XTC but do you have it enabled in the Scope "Settings"?

the19thbear · Post by **the19thbear** » Thu Jan 10, 2008 5:17 am

yes i have...

works fine in cubase sfp mode!!

Post by **garyb** » Thu Jan 10, 2008 9:55 am

who needs xtc mode?