Hardware test

Cochise · Post by **Cochise** » Fri Jul 13, 2007 7:53 am

How can I perform an hardware test for my CW boards?

Cochise · Post by **Cochise** » Fri Jul 13, 2007 10:48 am

No problem when I change latency or samplerate.
I instead have problems if I reach DSPs capacity limit. If, trying to increment the voice number, i've a run out of DSP, then though lowering the voice number i often get strange behavior. (But of course there's some unstability even without reaching DSPs capacity limit)

Shroomz~> · Post by **Shroomz~>** » Fri Jul 13, 2007 10:58 am

It's always worth trying a reset in the form of switching once between Master & Slave or vice versa in the Samplerate window. This can resolve system problems which occur occasionally after dsp capacity limit reached errors. Thanks to Astro for that top tip

Cochise · Post by **Cochise** » Sat Jul 14, 2007 6:51 am

Thx mates.