How to export Freq value to midi out in Modualr patch?

erminardi · Post by **erminardi** » Sun Jun 24, 2007 1:58 pm

Hi, anyone know how to "export" the freq value (from i.e. MVC A) to MIDI out on the modular patch?
I wish tweak a midi in with a ADSR, through freq conversion, and exit with the modified freq to midi message.
It's this possible?

Thanks in advance.

erminardi · Post by **erminardi** » Mon Jun 25, 2007 4:34 am

fra77x · Post by **fra77x** » Mon Jun 25, 2007 6:20 am

Hi erminardi,

The midi message doesn't include a frequency parameter. It uses note number. Then the MVC converts that number to frequency so to drive the oscillators.

erminardi · Post by **erminardi** » Mon Jun 25, 2007 12:05 pm

Thanks, so it's impossible to re-convert it to midi and export the signal outside after modular module?

FrancisHarmany · Post by **FrancisHarmany** » Mon Jun 25, 2007 10:35 pm

you are looking for a modular midi note generator ? Me too

Lima · Post by **Lima** » Mon Jun 25, 2007 10:45 pm

Have you tried the Wolf's midi tool box?
http://www.worldless.com/sfp/mtb.html

in particular this module:

"
The toolbox contains :

for scope:
[...]

for the modular:
val2note sends midi notes out of modular
val2control sends midi controller messages out of modular
audio2val converts the level of an audio signal to values
SoftTakeOver routes input only through if it is in a range of the output value
sync2async converts sync signals to async signals (very helpful, if you get the "cannot connect converter pads" alert)
"

FrancisHarmany · Post by **FrancisHarmany** » Mon Jun 25, 2007 11:07 pm

I guess its time to buy it

erminardi · Post by **erminardi** » Tue Jun 26, 2007 12:26 am

Interesting, thanks for the tip