Can two pulsar II and one Pulsar I coexist ?

musurgio · Post by **musurgio** » Fri Oct 27, 2006 6:17 am

hI,
Can two pulsar II and one Pulsar I coexist WITHOUT any problem on same computer ?
ULLI asio anyway is 25 ms so no latency problem here.
I know pulsar I has only one leg for stdm connection, maybe that could cause some problem, or ?
I will mainly use Pulsar I for I/O purposes.
Regards,
Dimitrios

ali · Post by **ali** » Fri Oct 27, 2006 9:53 am

There should be no problem mixing type 1 and type 2 pulsars

for ULLI make sure Pulsar II is #1and always in command this way you can get the lower latency of the pulsar 2

kyunghwee · Post by **kyunghwee** » Sat Oct 28, 2006 7:54 pm

Currently running PowerPulsar (15 DSP)

+ Pulsar Pro I (4 DSP)

+ Pulsar I SRB (4 DSP)

with ULLI set @ 7 ms (44.1 Khz) and everything works blissfully!
Other than having to slightly twist the STDM cable a little to manuver from the 2nd generation card to the 1st generation ones (since the location of the bus connectors is slightly different), they work in perfect harmony.