aside from the fact that my aiso drivers can't be found the pulsar card has also managed to wreck the 'restart' functionality of my pc,now when i choose the 'restart' the pc it resets but then doesn't boot....i need to switch it off and switch it on again.
has this happened to anyone here?
Pular 2 is ruining my system...
Here is an excerpt from the <a href=http://www.infinitevortex.com/default.a ... 3readme>V3 README</a>:
<ul>
Using the minimal ULLI setting of 3ms@44.1kHz may result in the "blue screen of death" or the system freezing up when you try to start Windows. If this happens, start Windows (in ¡¨safe mode¡¨ if necessary - start in safe mode by pressing F8 while starting Windows). Open the CSET.INI file (..ScopeSPAppBin) and locate the following entry:
[hw] intBlkSize=64
Edit the file to change the value from 64 to 128, 256, 512, or 1024. Save the edited file and restart Windows.
</ul>
Perhaps your ULLI is set too low for your system?
<ul>
Using the minimal ULLI setting of 3ms@44.1kHz may result in the "blue screen of death" or the system freezing up when you try to start Windows. If this happens, start Windows (in ¡¨safe mode¡¨ if necessary - start in safe mode by pressing F8 while starting Windows). Open the CSET.INI file (..ScopeSPAppBin) and locate the following entry:
[hw] intBlkSize=64
Edit the file to change the value from 64 to 128, 256, 512, or 1024. Save the edited file and restart Windows.
</ul>
Perhaps your ULLI is set too low for your system?
BTW, with WinXP, and a P4 1.8Ghz, I can run that setting after <a href=http://www.planetz.com/forums/viewtopic ... >tweaks</a>.