XTC on Pulsar 1 problems...

mcskelle · Post by **mcskelle** » Sat Jan 05, 2002 11:55 am

I just installed Pulsar 3.01 with my Pulsar 1 card. During installation i chose to install the XTC-option as well.

Now, I wan't to use it with Cubase VST32.

If i close my Pulsar OS and start Cubase, the ASIO driver have been changed from PulsarScope which i normally use, to the ASIODirecX-driver. It dosen't play a thing(audio or MIDI), and saids it has a 750Ms latency. Hmmm...

So off-cause I tried to change to the PulsarScope Asio driver, but thats not possible because "...blabla...no ASIO driver loaded or something"

What am I missing, what am i doing wrong here?

Whats the idea here? Isn't it to close the PulsarOS and do everything from within Cubase?

subhuman · Post by **subhuman** » Sat Jan 05, 2002 1:26 pm

If you want to use XTC Mode: Install using "XTC Mode" make sure it XTC is enabled under View > Settings, close Pulsar. Then open your sequencer and use Pulsar as VST plugins.

If you want to use Pulsar Mode: Uncheck "XTC Mode" under View > Settings, keep Pulsar open, make sure you have ASIO Source (ASIO2 24bit, etc) and ASIO Destination (matching your ASIO source) in your project, before opening your sequencer. Keep Pulsar open. Then open your sequencer.

Hope that helps.

mcskelle · Post by **mcskelle** » Sat Jan 05, 2002 3:42 pm

thanks Sub, for your answer!

The installation and enableing of XTC went just fine. It's installed all right and checked in the setting-panel in pulsar.

could you specifie a little what you mean by:

"Then open your sequencer and use Pulsar as VST plugins. "

Maybe you can answer theese question by doing that:

1.As I wrote, I'd like to use the Scope-driver-thing in cubase as i've allways done, instead of the ASIO-directX with the high latency. How to change drivers without getting the "ASIO not loaded"-error?

2.Where's the pulsar-synths?

3. Where's the bigMixer?

4. Can i somehow import pulsarprojects into my sequenser?

and many more:-)