Motorized Faders in Scope

pharohoknaughty · Post by **pharohoknaughty** » Fri Apr 14, 2006 8:02 am

Has anyone figured out how to use a Motormix with Scope's mixer, to recall settings to the faders?

Thanks

pharohoknaughty · Post by **pharohoknaughty** » Tue Apr 18, 2006 8:31 am

Bump!

Post by **garyb** » Tue Apr 18, 2006 11:19 am

not motormix, but an example that it's possible:
http://www.planetz.com/forums/viewtopic ... forum=32&5

recently, chisel has had a lot of luck with the behringer. here he first got feedback working:
http://www.planetz.com/forums/viewtopic ... forum=1&10
the motormix will be much the same....

Chisel · Post by **Chisel** » Tue Apr 18, 2006 3:28 pm

My advice would be to connect it to MIDI-OX to determine what kind of messages it is sending. Then you can use the MIDI learn function in the Scope mixer or if it's more complicated than that (i.e. uses pitch bend messages for faders or uses multiple channels) then you can use MIDI Transformer which is found in the Device section on this site. Good luck!

Peace /
Chisel