MIDI control of Scope FX

dawman · Post by **dawman** » Tue Apr 04, 2006 3:00 pm

I seem to have lost my control of Scope FX. My next gig does not allow house stage monitors, everything goes to FOH. So I go in to use my switch as B2003 leslie speed, and voila nothing works, it use to before I went to the Pro3t rotary cab. I can move a controller and it shows up in the window, but has no control over parameters. Is there something I inadvertantly shut off that I could recall? My controller works fine. I use to use this before, I obviously deleted something somewhere. Any tips?

_________________
Jimmy V.

<font size=-1>[ This Message was edited by: scope4live on 2006-04-04 16:01 ]</font>

valis · Post by **valis** » Tue Apr 04, 2006 3:10 pm

Midi is routed ok?

What 'window' are the controllers showing up in when you use a midi controller?

And, do you mean that right click & assign controller value isn't 'sticking' when u assign?

dawman · Post by **dawman** » Tue Apr 04, 2006 3:15 pm

It doesn't stick,or save. Controllers show up , but I might have deleted a file that was connected at one time before i started using rorary cab. I use to have mod wheel rate speeds for Phaza, and Tape Sim, no problems then. What could I have done?

MD69 · Post by **MD69** » Tue Apr 04, 2006 3:39 pm

Hi S4L,

If the link between B2003 and your controler is broken (I mean when you move your controler, the switch state is not updated):
- check that the controler assignation windows (the one you open when you want to assign a controler)is the one from the B2003 and not from another synth (check title). Reassign your controler (delete the old one and move your controler to add) also, check the option about using the device midi channel, and have the same midi channel in your device.

If all this sanity check fail, you might need to re install the B2003 (don't forget to backup your sfp/preset/b2003.pre as it will be overwritten) and if this fail maybe recreate your scope project from scratch (might have been messed up or your config have changed meanwhile). If I am correct (the last time I used SFP!), MDL controler assignation are stored in the project wherea DEV controler assignation are with the device.

Cheers

Michel

dawman · Post by **dawman** » Tue Apr 04, 2006 3:47 pm

I think I should re install Scope. This is the same trouble on all FX, and dev.'s.

MD69 · Post by **MD69** » Tue Apr 04, 2006 3:58 pm

hmm, try to create a new project and check if this work before to re install everything! Hope it is not your GS3 update which messed your config.

Best whishes

dawman · Post by **dawman** » Wed Apr 05, 2006 12:52 am

Thanks for your concern, I figure this out tomorrow.

dawman · Post by **dawman** » Wed Apr 05, 2006 3:41 pm

Thank You MD69,
I was ready to re-install everything, your common sense response of starting from scratch on a project, worked for me. I applied my GS3 upgrade while connected to Scope, for that is how I use the 2 apps, together. That is the only unexplainable reason which I could think of. I could care less now about it, as long as it works. I can handle going w/o Blue Tubes, and the extremely weak NFX, but don't mess with my Scope shit.

As You Were,

_________________
Jimmy V.

<font size=-1>[ This Message was edited by: scope4live on 2006-04-05 16:42 ]</font>

MD69 · Post by **MD69** » Thu Apr 06, 2006 4:36 am