I can't pass the -(IN Cubase)
AsioMultimedia Setup Test !-when i run it-
I get the message "the communication with the audio card has been lost"
Where can i look in to that ?
Arish
ASIO Multimedia problem ?!@
the asio multimedia test is concerning the wave modules loaded and is not related to the asio modules of pulsar but if you run it on default background.pro it should work as there are some wave modules in there.
if you work with asio modules you shouldn't run that test.
i don't know what is your problem exactly but i hope it helps.
ciao, alfonso
if you work with asio modules you shouldn't run that test.
i don't know what is your problem exactly but i hope it helps.
ciao, alfonso
Thanks
So,maybe you can help me with some input on this problem that i have !*--- When I records from Cubase to cubase (using the BigMixer V2b asio sourse- buss- to asio dest)
I get good result of sound !
But when i record straight from Pulsar to Cuibase(v2b to asio dest)
i get low and weak of sound ! it's happend also with a mono channel
This is my mixer setup that i use:
Asio 24 bit Source to -IN- 3 + 4
Asio24 bit Dest to-R1-R2
THE different IN THE SOUND is Noticeable ,
What do i miss here ?!
Regards
Arish
So,maybe you can help me with some input on this problem that i have !*--- When I records from Cubase to cubase (using the BigMixer V2b asio sourse- buss- to asio dest)
I get good result of sound !
But when i record straight from Pulsar to Cuibase(v2b to asio dest)
i get low and weak of sound ! it's happend also with a mono channel
This is my mixer setup that i use:
Asio 24 bit Source to -IN- 3 + 4
Asio24 bit Dest to-R1-R2
THE different IN THE SOUND is Noticeable ,
What do i miss here ?!
Regards
Arish
it's normal i think, it's just a matter of level. usually single mixer channels have to be mixed all together so there is some headroom left to have a full mix without distortion and their output on the busses is lower. check that you disable in the mix the channels you are sending to the busses if you are monitoring the busses too, otherwise you will perceive a much higher level than their real one. then you can rise the channels gain to get the nearest to zero level. i'm not sure i understood your problem
i'm using the pulsar mixer so i don't remember BM well.....
ciao, alfonso
<font size=-1>[ This Message was edited by: alfonso on 2001-12-26 17:40 ]</font>
i'm using the pulsar mixer so i don't remember BM well.....
ciao, alfonso
<font size=-1>[ This Message was edited by: alfonso on 2001-12-26 17:40 ]</font>