Can someone be so kind and tell me how to wire a mixer for the following:
I am coming with my external mixer into Pulsar (via Adat) and sending to Ableton Live a guitar signal through a BUS but I don't want to hear the unprocessed sound of the guitar!
So guitar - pulsar mix in via adat and then into ableton - guitar rig but when I am listening back I still hear my original signal of the guitar coming into the mix. I hope am not to confusing. Thank you very much.
wiring the mixer
hi
Don't know Ableton Live, but guess it's ASIO's, so:
Guitar > mixer > adat1 >stm mixer1 >mixer ch direct out > ASIO-dest1 and ASIO-dest2
Connect guitar rig to asio ch1 or 2
This gives you 2 signals to Live, and 2 Set separat ASIO out from Ableton Live.
Now you can record signal 1, 2 or both and monitor signal 1, 2 or both
I suppose Ableton enables you to do this inside the software too, via 1 ASIO source and out from Abletons mixer, to as many ASIO dest you want.
<font size=-1>[ This Message was edited by: arela on 2006-03-03 00:17 ]</font>
Don't know Ableton Live, but guess it's ASIO's, so:
Guitar > mixer > adat1 >stm mixer1 >mixer ch direct out > ASIO-dest1 and ASIO-dest2
Connect guitar rig to asio ch1 or 2
This gives you 2 signals to Live, and 2 Set separat ASIO out from Ableton Live.
Now you can record signal 1, 2 or both and monitor signal 1, 2 or both
I suppose Ableton enables you to do this inside the software too, via 1 ASIO source and out from Abletons mixer, to as many ASIO dest you want.
<font size=-1>[ This Message was edited by: arela on 2006-03-03 00:17 ]</font>