problem between scope pro (4.5) and cubase sx3.11

[nerhyad]

hello,

first excuse me for my bad english ;o)
i just buy a creamware scope pro 4.5 and i want to use it with my cubase sx 3.11
in scope i put enable xtc, the xtc folder is in my vstplug folder of cubase,
in cubase i haven't get scope vst instrument and effect so i look cubase plug information and i see that all creamware plug are in the folder inchargeable,

do you know how to resolve this problem???
if not can someone explain me any part of installation perhaps i make a mistake???( setting in scope ...)

thanks a lot

[garyb]

to use xtc mode, you must close scope BEFORE opening cubase. there are many good tips on xtc mode in the tips and tricks and xtc forums....

[nerhyad]

thanks a lot, my scope is closed i don't see my problem in the forum if you get idea ;o)

thanks

[garyb]

open the plugin information window(i believe that's what it's called, i'm not in front of my rig right now!)in cubase and enable the cwa plugins(check box).

actually, others HAVE had problems loading their xtc plugins here before, so the answer is likely to be in old posts. i think everybody's eventually figured it out, so hopefully we'll figure it out in this case as well....

also, my standard behavior is to suggest that you use scope mode. it has many more possibilities and you can still use your scope effects. you just need to think of cubase as a hardware mutlitrack ala a vs-880(with midi), in a room(which is the scope environment) and then things are MUCH easier and more sensible(well, if you are familiar with hardware).....


<font size=-1>[ This Message was edited by: garyb on 2006-02-11 10:59 ]</font>

[nerhyad]

Thanks,

i try to mark all plug in plug folder in cubase but for cubase plug aren't valid???
i don't know why,
i could try your method but i don't know how !!!