SFP starts automaticlly with Windows

[Christos]

Hello,
I just installed Scope 4.5 from 3.1c, and SFP keeps booting automatically after Windows. I have unchecked the active project at startup in the settings tab, but it keeps doind it. I would appreciate any suggestions.
Thank you

P4 3.0Ghz, Intel 875PBZ, 2 Gb Kingston, Matrox Parhelia, 2X80 & 160 WD, 2 X Pulsar II Plus, Nuendo 3.2, Gigastudio 2

[arela]

Windows > run > msconfig
uncheck SFP
(IT'S IN STARTUP FOLDER in msconfig)

sorry for GIANT FONTS

[ARCADIOS]

hi christos! ti habaria?

the settings that you have unchecked is for using scopes project as default or startup each time scope lounches.
after installation, scope always is set to run with windows startup.
just uncheck in msconfig

[geoffd99]

Hi all

My 4.5 install didn't load the new plugins (for some weird reason CW couldn't figure out) so I have them all registered to 4.0.

But Startup is 4.5 (as above threads).

How do I change the Startup launch back to 4.0?

Thanks!

[Christos]

Hallo guys
That was it. Thanks for the support.

[arela]

Hi geoffd99
Are you shure your 4.5 files are complete.
Have you tried to install the plug-in later.

Or is it the folder that is SFP4?
Scope 4.5 installed over 4.0, so that's ok.

[geoffd99]

sfp4.5 is in its own folder, and starts up fine with Windows.

sfp4.0 is also OK, and to use it, I just stop 4.5 and start 4.0.

But this would be easier if it started with XP Startup.

The plugins didn't register with 4.5, no one at CW could figure out why, so they registered them to 4.0.

This is fine, except I have a useless v 4.5.

Not a major problem though.

[geoffd99]

Yes this worked fine thanks!