Hi all!
I have a luna II ,I work with logic 4.7(asio dr.). I can't hear the click, could somebody tellme wich is the right way to connect the modules to hear it? The "midi setting" menu in my logic is different from the one shown in the luna manual!
I'm new to Puisar, and I need your help!
Thanks a lot!!!
Francesco
<font size=-1>[ This Message was edited by: fra.aie on 2001-12-09 14:47 ]</font>
What do you use as the click sound? The STS sampler? The exs24 sampler? and old sblive? You have in fact to have a sound generator somehere and route the click icon in logic to his device and port
...So I should have a "sound source", for the click?! I just have my luna as audio device, no have STS & I don't know what is exs240!!!Could I do without? or I won't have my damned click?
Could you explain it to me?
Many Many Many Many thanks!
Francesco
in cubase anyways, the click can be MIDI or Audio. marcuspocus was talking about using logic to triger something VIA midi for the metronome sound. if you don't have any midi gear, just use the audio click and monitor the signal from the driver out. this should be covered in your logic manual. i presume logic has this function in the metronome settings dialogue, but may be mistaken.
in the transport, hold down the left mouse button over the metronome button. A menu should appear were u can decide wich port to use the click. It works like that on mac at least.
<font size=6> RTFM!
<font size=-1>[ This Message was edited by: Air_PoLLo on 2001-12-11 16:51 ]</font>
Sounds simple, but I'm also new at this and I had the same problem until I patched the sequencer MIDI source to the MIDI dest. . .sometimes the obvious is the killer. . .
justin