Samplerrate setting problems....

Krooz · Post by **Krooz** » Sun Jan 15, 2006 7:30 am

Hi Guys,
I have a Pulsar 1 and 2 boards in my system running SFP V4.0. I've been running these boards together without problem for several months. However in the last few weeks i've developed the following problem - None of the drivers appear to work when i'm loading logic / soundforge / trying to get analogue audio into the system.

At first this seemed to be sorted with a reinstall of SFP. However this is no longer working.

On doing further research i noticed that although the Samplerrate Settings window - (which is slaved to my EMU samplers ADAT) says it's connected but the little grey box in the top left that usually says 44.1k only contains '--' I've Checked the seeting on the EMU which says it's at 44.1
I've also tried putting the pulsar on master setting and still it's reading '--'

Short of trying a complete clear down and reinstall of windows and reinstall of sfp i'm a bit stuck on where to go next.

Any ideas of anything else i could check would be greatly appriciated.

<font size=-1>[ This Message was edited by: Krooz on 2006-01-15 07:30 ]</font>

at0m · Post by **at0m** » Sun Jan 15, 2006 9:07 am

I've also tried putting the pulsar on master setting and still it's reading '--'

Short of trying a complete clear down and reinstall of windows and reinstall of sfp i'm a bit stuck on where to go next.

support @ creamware ?

Krooz · Post by **Krooz** » Sun Jan 15, 2006 9:41 am

I've emailed creamware - but as it's over the w/e i know they won't be around - i thought someone may have similar issues over here and i'd ask here too.

Cheers

<font size=-1>[ This Message was edited by: Krooz on 2006-01-15 09:41 ]</font>

djmicron · Post by **djmicron** » Sun Jan 15, 2006 10:18 am

i've encountered the same problem and the cause was the stdm cable (i forgot to connect it).

Check the connection of the stdm cable and if it does not solve the problem, try to remove one of the 2 cards and run scope with just one of them and if it works, i think you need a new stdm cable.

Micron

Mr Arkadin · Post by **Mr Arkadin** » Sun Jan 15, 2006 10:49 am

i was going to suggest the same. Try re-seating the cards as well as the STDM cable - give everything a good bit of friction cleaning.

Krooz · Post by **Krooz** » Sun Jan 15, 2006 11:59 am

Cheers Guys.

Will give this a go and see if it solves it - i have had problems with it saying one of that cards isn't connected every now and then. but it always seems to sort itself out.

So this sounds like the likey cause.