My first post in this hopefully very helpful forum
I have two Scope Project cards (one classic and one XTC retrofitted with ADAT I/O). I run Windows XP SP 2. In the scope application all works fine, I run guitar throught preamp->spdif in->scope->spdif out->g-major. But when I run the same setup in Cubase SX 3 I get sound input on the meters, but no output. I also cannot playback ordinary sound files, mp3's and so on, it says "The hardware caonnot playback this kind of file" (on .mp3 and .wav files)!! Any ideas??
Regards,
Peter
For Cubase:
Pulsar2 SP-DIF SOURCE > scope mixer chn 1
From mixer chn 1 (or MIX L/R if you don't intend to use direct out) > ASIO DEST
...now you have signal to Cubase, then
ASIO SOURCE 1 > scope mixer chn 2
...now you have signal out of Cubase
To play from eg mediaplayer, you need to connect a wave source to the mixer.
no. scope is not a simple windows soundcard. scope is a hardware environment, the routing window is required. for music production, this is a good thing. for games and such, it might be a bit of a bother.