Why are all of my external recordings Phased :(

[JazzBee]

Hi Guys,

I recectly purchased a scope home bundle with dsp card & Luna Z-Link analogue 8in 8out box and I'm a newbie to the scope interface.

My problem is that every time I try to record any of my external synths or any other external signal into my Cubase SX 2.0 I always end up with a phased sound (the sound seems to be going in twice), I am pretty sure that I may have screw up somewhere in my routing window but just can not figure out why this is occuring!

I have every output (Luna Z-link, wave, asio, etc..) going into the scope software mixer (STM 1632) on different channels but on the recording input I have connected all of the deviced (z-link, asio, wave, etc,..) into the main left & right input of the mixer.

Can anyone please help... I really like the sound quality of the scope but am seriously considering selling it & getting a simpler card as I just can not figure this out

[petal]

It will take a long time to get to kno your Scope system, but there's a lot of benefits to this advanced system. So welcome aboard, we're here to help you through these first difficult steps

Sounds to me as if you are recording both what is going through the Scope-mixer and what is coming out of Cubase.
Could you perhaps post a screen-shot of your routing-window, then I think this problem will be easily solved.

Thomas