cubase

ms · Post by ms » Mon Jul 25, 2005 9:31 am

when using cubase i am having trouble with effects when i put an effect on in cubase(while using a guitar)i cannot hear it during recording i can just hear it during playback can any 1 help?

at0m · Post by **at0m** » Mon Jul 25, 2005 11:56 am

ms, turn off 'Direct Monitoring" in SX > Devices > Device Setup > VST Multitrack. This will route any monitored ASIO inputs to their channel, inclusive effects, and than to the assigned output.

Direct Monitoring sends all inputs that have monitoring enabled directly on the card (not via the drivers) to ASIO 1L-R. This bypasses the ASIO drivers and is realtime.

Disabling Direct Monitoring introduces 2 times the latency your ASIO is set to. see SFP > Set > Settings > ULLI. If that's 13ms, you will hear delay on your playing.

If you'd use Scope fx, it would be realtime. I never monitor through SX, route anything to analog output of SFP, in SFP, to be honest.

ms · Post by ms » Mon Jul 25, 2005 12:57 pm

hey turned off direct monitoring and still can only hear my guitar with out any effect despite an effect being put on it cud i b doin anythin else wrong?