It's been a while - changeout of Scope I/O plates problem.

takieda · Post by **takieda** » Fri Jul 22, 2005 1:25 pm

Okay, it has been a long while, but I'm finally getting the studio on board this boat in a much more complete and concise system. I'm now running a scope professional with Z-Link plate, and an A-16 Ultra plugged into that. Lots of other fun stuff too.

The problem is, I've switched out the I/O plate on this card from the Plus plate to the Z-Link plate, and now have a few problems (needless to say, I haven't switched out the drivers.) I started looking at switching out drivers and the software, etc, and realized that it was going to require a lot of research before I get started.

What I want to know, basically, is if it's okay to just uninstall and reinstall the driver, or should I reinstall the Scope 4, or what? what would be the best way to go through with this as things worked before I switched out the I/O plates, and I don't think there's really a problem with anything else in the setup.

Be well,
-Tak

<font size=-1>[ This Message was edited by: takieda on 2005-07-22 14:25 ]</font>

Post by **Guest** » Fri Jul 22, 2005 4:29 pm

you may do both reinstall software on tope and update driver.

But what are some of these problems??

takieda · Post by **takieda** » Sat Jul 23, 2005 1:27 pm

Well Scope was telling me that the interface wasn't right for my I/O plate (or something to that effect - fixed the problem so I forget what it was).