Connecting A Scope Project card with Scope Home

youngsta · Post by **youngsta** » Fri Jun 24, 2005 3:31 pm

Hey y'all got a little question...
I own a pulsar II cad and i recenly puchased a scope home card. How should i connect these cards to make them function as 'one' ?
Thnx

Post by **hubird** » Fri Jun 24, 2005 3:34 pm

youngsta · Post by **youngsta** » Fri Jun 24, 2005 3:44 pm

Lost the manual so that's kind of a bummer : (

alfonso · Post by **alfonso** » Fri Jun 24, 2005 3:49 pm

You need an STDM cable that your reseller should provide.

Post by **hubird** » Fri Jun 24, 2005 3:54 pm

you need a 'STDM' cable to connect both cards at the STDM connectors.
SFP will immediately and without any problems see both card's `DSP's as 'one'.
With two cards, use the 'ends' of the three-point cable, as termination is involved.
Ask your dealer or order one from CWA.

<font size=-1>[ This Message was edited by: hubird on 2005-06-24 16:55 ]</font>

Post by **Guest** » Fri Jun 24, 2005 3:59 pm

Manual can be downloaded here

English
http://www.cwaudio.de/download/software ... v40_en.zip

German
http://www.cwaudio.de/download/software ... v40_de.zip

French
http://www.cwaudio.de/download/software ... v40_fr.zip