Latency Changed

ddoctornt · Post by **ddoctornt** » Thu Jun 16, 2005 11:04 pm

I have a luna1 card and in cubase and logic the
latency was 3ms I have now added a pulsar1
card and the latency now will not go below 14ms

Can any one help me

alfonso · Post by **alfonso** » Thu Jun 16, 2005 11:23 pm

Old Pulsar 1 cards, if set as main cards can't go lower in latency. But I have a P1 together with 2 second generation cards and I can go down to very low latency if I want.

In the paper manual there should be a chapter about editing a line in the cset.ini file (open it with notepad) for swapping the order in wich the cards are recognized by your system, but I don't have it now.

You could instead swap card position in the pci bus, this will very probably cure the issue.

If you do so, I recommend first to disable the startup project load when booting windows (reboot to check), then to uninstall card drivers, after that you swap card positions, reinstall the drivers, re-enable startup project (if you need it) and should be fine.

Just a curiosity...when you open the DSP usage panel, wich card is listed first now? if you have it properly you should see DSP's like this : 1/1 1/2 1/3 2/1 2/2 2/3 2/4 that means that the 3 dsp card, Luna, is the first one.

Now that things are wrong you should see 1/1 1/2 1/3 1/4 2/1 2/2 2/3, where the old P1 shows as first.

How is it?

ddoctornt · Post by **ddoctornt** » Tue Jun 21, 2005 12:11 pm

Thanks for the info I reinstalled the drivers and its back to 3ms in xtc mode. But now I cant seem to get it to go in 96khz it says the stdm cable on device 1 is missing

samplaire · Post by **samplaire** » Tue Jun 21, 2005 11:11 pm

And have you got one? If not - it's required if you have >1 card. If you have it installed then you have to reseat it. Hope this helps

ddoctornt · Post by **ddoctornt** » Wed Jun 22, 2005 8:22 am

Got one cable connected with only the outer connecters works in 33 44 and 48kHz just not 96kHz