Mixer Routing

garygiles · Post by **garygiles** » Fri Jun 03, 2005 9:14 am

Hi All

I am having problems with the Bus & Aux routing on my Creamware Scope Pro.

On booting up into a file which has a Mixer STM 24 48 setup, no audio passes through both Auxes and Buses. I have to click on the Bus routing or switch the aux on and off on the channel to get signal out.

Has anyone had the same problems?

<font size=-1>[ This Message was edited by: garygiles on 2005-06-03 10:23 ]</font>

Ricardo · Post by **Ricardo** » Thu Jun 09, 2005 5:25 am

Hi, not sure what you're trying to say but, you must assign your bus outs and enable aux sends.

garygiles · Post by **garygiles** » Thu Jun 09, 2005 7:07 am

Thanks Ricardo,

I did'nt explain myself very clearly.

I have already saved a file were I am using a Mixer STM 24 48 and have assigned my buses and enable the aux sends.

The problem occurs when I re-boot into the same file on Scope Pro.

No audio passes through both Auxes and Buses even though they are already routed and enabled. I have to click on the Bus routing or switch the aux on and off on the channel to get signal out.

Regards

Gary

Ricardo · Post by **Ricardo** » Fri Jun 10, 2005 5:41 am

That's a tricky one. Sounds like the project isn't saving properly. I'm afraid I don't know the answer. hopefully someone will.
BTW if it was me I'd try doing a reinstall of SFP

garygiles · Post by **garygiles** » Fri Jun 10, 2005 9:45 am

HI

I will it now seems fine now. The 1st time it happened I did have to click on the routing and the sound would then kick in. But since then so far it been fine. Its been useful having the SCope on the show.

Regards

Gary

_________________

<font size=-1>[ This Message was edited by: garygiles on 2005-06-10 10:45 ]</font>