LiveBar on startup

garygiles · Post by **garygiles** » Thu Jun 02, 2005 2:06 pm

Hi All

Can someone tell me if there is a setting so I can always the see the LiveBar on startup of my PC. It's useful to see when Scope has finished loading all its devices so I don't open any other programes before Scope has finished.

Regards

Gary

[ This Message was edited by: garygiles on 2005-06-02 15:08 ]

Post by **Guest** » Thu Jun 02, 2005 2:46 pm

while the live bar is present on your screen make sure that you save the project under setting,to load at start up.

in the live bar go to set /settings/projects then click on save project as startup

Post by **hubird** » Thu Jun 02, 2005 3:13 pm

garygiles · Post by **garygiles** » Thu Jun 02, 2005 7:19 pm

Antar

Thanks for your suggestion but I am sure I have tried this a 1000 times already but it only ever shows up on the startup tray 1st then I have to click show.

I have seen it show up but then it just stopped and I'm not sure why.

I will try it again when I get back in to work.

Regards

Gary

On 2005-06-02 15:46, antar wrote:
while the live bar is present on your screen make sure that you save the project under setting,to load at start up.

in the live bar go to set /settings/projects then click on save project as startup

garygiles · Post by **garygiles** » Sat Jun 04, 2005 1:45 am

Hi

Fixed the problem by editing the RegEdit file.

G.

[ This Message was edited by: garygiles on 2005-06-04 02:45 ]

alfonso · Post by **alfonso** » Sat Jun 04, 2005 4:07 am

On 2005-06-04 02:45, garygiles wrote:
Hi

Fixed the problem by editing the RegEdit file.

G.

[ This Message was edited by: garygiles on 2005-06-04 02:45 ]

Could you post how in the Tips & Tricks forum?

garygiles · Post by **garygiles** » Sat Jun 04, 2005 6:27 am

Hi

I fixed it by going into

HKEY_LOCAL_MACHINESOFTWAREMicrosoftWindowsCurrentVersionRun

and then removing -s at the end.

G.