Standalone and sequenzer

[diminu]

Hi,
is there any possibility to run a standalone synth together with a sequenzer in Scope?

[paulrmartin]

Drop a couple of Wave Sources in your Scope project and assign outputs in your Standalone to one of them and sequencer to the other.

Easier than that, Drop an ASIO source in your project, assign 4 outputs in it and assign the standalone and sequencer output to their respective slots.



<font size=-1>[ This Message was edited by: paulrmartin on 2005-05-04 17:16 ]</font>

[diminu]

@paulmartin
Hi,
thanks for the reply. I´ve done so like you recommended. But whenever I open the standalone synth i get the Error: " Scope fusion is not running or ASIO source or ASIO dest are not included in your current system". But they are!

Greetz
diminu

[Music Manic]

On 2005-05-04 17:32, diminu wrote:
@paulmartin
Hi,
thanks for the reply. I´ve done so like you recommended. But whenever I open the standalone synth i get the Error: " Scope fusion is not running or ASIO source or ASIO dest are not included in your current system". But they are!

Greetz
diminu

Are you on Scope V4.0?
Seems to create this problem all the time for me.Re-install Pulsar card drivers and try again.

[Guest]

Asio Source/destination must be loaded in your creamware routing windows before you start your sequencer. and don't close creamware software.


<font size=-1>[ This Message was edited by: antar on 2005-05-04 19:23 ]</font>

[paulrmartin]

Make sure your Scope is not running in XTC mode.

[garyb]

you can only connect asio to one app(asio's not multiclient). the other must use a wav module.

[hubird]

exactly...

[diminu]

O.K.
Thank you

diminu