![:smile:](./images/smilies/icon_smile.gif)
I use only XTC mode in cubase SX 2.2.0.33. my SFP release is 4.0.
well:
when i set my card's outputs i can flag the pulsarII & powersampler outputs but in cubase the pulsar outputs is the only activated: no powersampler outputs!, the dsp works right but no powersampler outputs. even i can't assign the directplay to PS Analog output.
I have try editing XTCprocject.pro inserting manually PS Analog output, connected to a new AISO output:
![Image](http://www.burdello.com/dmdocuments/XTCproject.gif)
now i can use two outputs to monitoring recordings but, if i set directplay to PulsarII Analog output and i press the directplay function on a sinth these message error is prompted:
![Image](http://www.burdello.com/dmdocuments/erroriXTC.gif)
note: in my cset.ini:
[XTC-Config]
DirectPlayOutPad2=RIn
DirectPlayOutPad1=LIn
DirectPlayOut=Pulsar2 Analog Dest
AddHost=2
[Host]
Scoperev=128
[Host-Config]
Numboards=2
Board0=Host
[hw]
numboards=2
intBlkSize=256
Please give me a solution!!!
ciao
![:smile:](./images/smilies/icon_smile.gif)
<font size=-1>[ This Message was edited by: burdello on 2004-11-13 21:27 ]</font>
<font size=-1>[ This Message was edited by: burdello on 2004-11-25 13:18 ]</font>