Asio not Included In your project?

deep2112 · Post by **deep2112** » Mon Feb 21, 2005 6:55 am

Hi everyone,

Aim using Scope 4 home, with Cubase SE, Reason and Amplitud Live. With Cubase and Reason, I have no problems, but when I use Amplitude Live I get a pop up window that says that no asio drivers Included In your project. Now this Is not true, as I do have a Asio dest and source driver In my project window. Since I Installed Amplitude Live, I have only heard It twice. I have not changed anything In my project window so I dont know what Is going on. Its a shame cuz Amplitud sounds real good, but I dont know how to get It working again. Any help please? Thanks.

valis · Post by **valis** » Mon Feb 21, 2005 7:05 am

Nothing else is using the ASIO drivers at the time of the error message?

deep2112 · Post by **deep2112** » Mon Feb 21, 2005 8:33 am

Not that I know of. Scope loads at start up, then I launch Amplitud, so nothing should be using the asio driver but Amplitud. I even got to record Amplitud on Cubase SE once with no problem. Never again have I heard Amplitud work. I use a exclusive PC as a DAW (XP home, which I had to buy so Cubase would work, everything on It Is original)

<font size=-1>[ This Message was edited by: deep2112 on 2005-02-21 08:38 ]</font>

valis · Post by **valis** » Mon Feb 21, 2005 6:33 pm

And you never experience this with other audio applications right?

next to nothing · Post by **next to nothing** » Mon Feb 21, 2005 11:02 pm

stupid question, but we have to start spomewhere; u sure Cubase is set to use scope asio and not wave or directsound?

Zer · Post by **Zer** » Tue Feb 22, 2005 10:57 am

I'd suggest saving the *.pro and restarting the machine.

Booster · Post by **Booster** » Thu Feb 24, 2005 5:08 am

I've been having the same problems. When I checked my devices, I found that one IRQ was used twice. Not even by the Pulsar, but two other devices in my PC. Windows XP allows this, but the devices can screw-up your PCI slots.

So check if you have IRQ-doubles and try to uninstall the complete Scope software and drivers, and put the card in another PCI-slot. Reboot and reinstall the drivers. It worked for me!

<font size=-1>[ This Message was edited by: Booster on 2005-02-24 05:12 ]</font>

Herr Voigt · Post by **Herr Voigt** » Thu Feb 24, 2005 6:22 pm

In my case, it wasn't necessary to uninstall and reinstall. Just change the slots!

Post by **garyb** » Fri Feb 25, 2005 4:28 am

stupid question: you DO know that you have to set up your project to fit the job you are doing, right?