XTC with Pulsar Analog Inputs???

Man-Machine · Post by **Man-Machine** » Sat Feb 12, 2005 9:48 pm

Ok, I have no problems using synths in XTC but I just tried using a mic with Pulsar inputs and I get no signal in the Cubase inputs. In my XTCProject I'm routing the Analog source to the ASIO dest. Isn't it right? Maybe there's something I need to do in Cubase to hear the input signals. It does show two active Scope input signals in Device Setup though. Ideas???

Post by **garyb** » Sat Feb 12, 2005 9:57 pm

using a mic pre?

scope mode is better for that type of work....

Man-Machine · Post by **Man-Machine** » Sun Feb 13, 2005 8:33 pm

Yep, I got a mike gain going...

I just tried it on SPF and it works fine so it's gotta be something on my XTC project. Like I said, the synths work fine in XTC mode with my project but not the analogue source. Does anyone have a sample XTC project that have the synths and the analogue source working?

Thanks for all the help

Post by **garyb** » Sun Feb 13, 2005 9:13 pm

if you have the analog source routed to the asio dest 1 rl in the xtcproject.pro, it definitely should work.

zezappa · Post by **zezappa** » Mon Feb 14, 2005 6:17 pm

monitoring activated...?

Man-Machine · Post by **Man-Machine** » Mon Feb 14, 2005 7:18 pm

I'll check that again but it should be. Like I said, it works in SPF mode and my Cubase project is the same...

_________________
L8ter Oscill8ters!

<font size=-1>[ This Message was edited by: Man-Machine on 2005-02-14 19:19 ]</font>

Man-Machine · Post by **Man-Machine** » Wed Feb 16, 2005 5:50 pm

I just re-did the merge module connections and now I get input in SX. Weird...

Another weird thing is that when I bypass the DirectMixerPlay module and go direct from the asio source to the analogue out I get no sound. I thought this module was only to help with latency and wasn't really necessary...

_________________
L8ter Oscill8ters!

<font size=-1>[ This Message was edited by: Man-Machine on 2005-02-16 17:51 ]</font>