New Member says thanks + here is my problem

petrol vendor · Post by **petrol vendor** » Sat Jan 29, 2005 8:33 am

Hi there. I have been reading this forum for some time and it has always been very helpfull and informative. Thank you. Now I have a problem so its time for me to join and ask for help. I recently noticed the old sfp 3 softwere still being on my pc. I don´t need it, so i do the automatic uninstall. That uninstalled my SFP4 as well. Apparently those only go together.
Annyway, after reinstalling there is no asio-scope driver in cubase sx anymore (only multimedia directx). I uninstalled/reinstalled SX as well, but its still the same.
I hope someone can halp me to keep the music going.

AJAnderson · Post by **AJAnderson** » Sat Jan 29, 2005 4:02 pm

ok goto the web site http://www.creamware.com

And follow instructions for getting version 4..if you have already done this ,, i am sorry for stating the obvious.... i had no problems.... check ur drivers are installed...other than that read the instructions on the web site..

take care

Post by **garyb** » Sat Jan 29, 2005 9:56 pm

do a search for creamware and scope after uninstalling and delete all the entries. then start over with a fresh install.

wolf · Post by **wolf** » Sun Jan 30, 2005 5:48 am

If reinstalling scope doesn't help to get back the asio drivers (which it always did here), have a look at the registry, search for asio (HKLM/Software/ASIO/ASIO SCOPE/ and look, if the entries for scope are damaged.
There should be written a CLSID.
Use this ID for searching again, the data entry should point to the place, where your ASIOScop.DLL is installed. If it doesn't, either edit it, so it points correctly to it or delete both entries (of course with exporting both keys before) and reinstall scope again.

hope this helps.

cheers
Wolfgang