Asio2 not working

hansheiser · Post by **hansheiser** » Sun Jan 23, 2005 11:04 am

hi. excuse my bad english.

I'm using pulsar II 24 adat with three behringer ultragain ad/da-converters. So far so good. My problem:

Direct monitoring works on all 24 channels, also recording in multi-record-mode (cubase vst) on 24 channels simultanously. But when I play back the tracks, I can only hear output on asio pairs 1 and 2, all others remain silent. I have tried different asio2-devices in sfp, but none is working. So when I want to mix a song finally, I have to take an asio1-device. Is there a way to workaround?

thanks in advance.

ThomasT · Post by **ThomasT** » Tue Jan 25, 2005 5:47 am

Are the busses activated in Cubase?

Open the master mixer. You see the master (1L/1R) and the additional busses (2L/2R, 3L/3R...) correspondig to your ASIO-outs in Scope-Project.
There is a green field on this channels. It must lit. If it is dark the channels are muted.
Click on it.

hansheiser · Post by **hansheiser** » Tue Jan 25, 2005 5:55 am

Yes, they are. When I use Asio1 source and Asio1 Dest in pulsar setup everything works fine. But Asio2 devices don't do the job though direct monitoring is working on all 24 channels.

ThomasT · Post by **ThomasT** » Tue Jan 25, 2005 6:55 am

Sorry, I didn't read it.

Check this out:
Open the mixer.
Under each channel there is the bus to which this channel is routed. "bus3" etc.
Set it again to "bus3". Does it work then?

And yes ASIO2 seems to be buggy.
I sometimes have the problem that the channels "forgot" they bus during "direct monitoring" and reactivating the bus helps.
I'm interested if this problem correlates to yours.

hansheiser · Post by **hansheiser** » Tue Jan 25, 2005 2:53 pm

I'll try it and tell you tomorrow evening. thank for reply!

hansheiser · Post by **hansheiser** » Tue Jan 25, 2005 7:33 pm

hi again. tried it. the only functional output is the left channel of asio pair 1/2. any other suggestion?