Hi all,
I got this strange problem. My system consists of a Pulsar 1 + Pulsar 2 in cascade and a uad-1 card on a PB4/533 with 1GB of RAM and a lot of disk capacity.
The problem I've got is this. Whenever I mix a project (in Nuendo2) and set the balance the way I like, next time I load the project, all of the balance seems to be lost.
In example I've got a hihat track that's quite burried in the mix, next time I load the project it's way louder than the entire mix. Definitely not the way I set it before saving.
The way my stuff is routed is as follows. Asio (32bit float) out goes to the stm1632 mixer, mixer output goes to my monitoring setup. (a very simple path I would think)
Does anyone recorgnise this problem and is there a solution for it? I really don't know if it has anything to do with the Pulsar cards, but noone using both uad-1 and/or Nuendo seem to have this problem. That's why I'm asking it overhere.
Any help or suggestion would be appreciated, since I got no more hairs to pull from my head, trying to figure it out....
Thanks in advance.
Best regards,
MG