Never change a running system...I did and I get the invoice...
Ok...I though version 4.0 works fine now.
I made a "prototype" of my new mixing project.
32 tracks including a lot of comps and EQ.
A 2448 mixer and a dynamic mixer in chain.
Every channel of the 2448 got some controllers on channel 15 (fader, solo, mute, pan, 1aux).
And 8 of the dynamic mixer channels as well (fader, solo, mute, aux).
The midis are connected with midi merge moduls.
During project loading only the 2448 sends the controller datas. Only one(!) channel of the dynamic mixer. The sends are important because of my motorized hardware controller.
I played a little bit.
It was impossible to assign controller 03 of channel 16 correctly to a fader of dynamic mixer. I can assing the controller, but I cannot move the fader via hardware controller, not the controller value will be send when moving it with the mouse. Assingning another controller (e.g. 119) works.
Again. My project became larger and larger.
Now even the 2448 does not send the correct values!
I hate this. What's wrong?