PulsarII pro & Powersampler in XTC

burdello · Post by **burdello** » Wed Nov 24, 2004 5:01 pm

In XTC mode I can see both powersampler & pulsarII I/O in the ASIO configuration box.
When I set powersampler i/o, after reloading I haven't it active.
I need powersampler output activated to monitoring recordings.
can someone help me?

burdello · Post by **burdello** » Wed Nov 24, 2004 6:02 pm

i have just do disconnect pulsarII from my pc:

now I have only powersampler in my pc.
under cubase, in i/o settings i can find only powersampler:

i check analog out & analog in, check "reload", then in VST connection:
Powersampler analog i/o is not active!
help me please

Post by **garyb** » Wed Nov 24, 2004 11:34 pm

you need to properly set up your xtcproject.pro in sfp/app/xtcapp. it is set up similarly to a normal project in scope mode

symbiote · Post by **symbiote** » Wed Nov 24, 2004 11:34 pm

Mm I think the project that XTC uses is SFPAppXTCAppXTC.pro, you could try loading the project in SFP and see if the Powersampler Analog Dest modules are present in the project.

Post by **garyb** » Wed Nov 24, 2004 11:36 pm

On 2004-11-24 23:34, symbiote wrote:
Mm I think the project that XTC uses is SFPAppXTCAppXTC.pro,

that's correct except it's xtcproject.pro not xtc.pro......

symbiote · Post by **symbiote** » Wed Nov 24, 2004 11:57 pm

Oops, thanks for pointing it out ^_^

burdello · Post by **burdello** » Thu Nov 25, 2004 7:14 am

now i can use two outputs to monitoring recordings but, if i set directplay to PulsarII Analog output and i press the directplay function on a sinth these message error is prompted:

it seems that powersampler outputs can't be loaded in XTC. is it real?

is there someone who use PulsarII & Powersampler (or luna) in XTC mode?

burdello · Post by **burdello** » Thu Nov 25, 2004 7:19 am

I hope edit cset.ini can be a good idea, but I don't know how.

note: in my driver list powersampler card is: "creamware dsp board"

<font size=-1>[ This Message was edited by: burdello on 2004-11-25 07:22 ]</font>