My Win XP is configured to 'Standard PC' and not ACPI. My existing card the Audiophile 2496 works fine but I had a look at the IRQ settings that the card was on and I'm a bit worried about what will happen when I install the Scope Pro card (I'm removing the Audiophile). My IRQ's are as follows:-
Resources by type:-
Only PCI IRQ 5 and 11 are used
PCI 5 Intel(R) 82801EB Ultra ATA Storage Controllers
PCI 5 Intel(R) 82801EB USB Universal Host COntrollers - 24D7
PCI 5 Intel(R) 82801EB USB2 Enhanced Host COntrollers - 24DD
PCI 5 M-Audio Delta Audiophile
PCI 11 Intel(R) 82801EB SMBUs Controller - 24D3
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24D2
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24D4
PCI 11 Intel(R) 82801EB USB Universal Host COntrollers - 24DE
PCI 11 NVIDIA GeForce FX 5900XT
Resources by connection:-
The same as above
There looks like a lot a stuff sharing the IRQ with my soundcard ?
What do you suggest I do when I install the scope board.
I cannot disable the USB ports in the BIOS because I use them in the other 2 partitions I have.
Do I simply need to put the cars in a different slot ? - I could get rid of my old dial-up modem - I have broadband now.
Thanks for any advice
My motherboard is an ASUS P5P800
<font size=-1>[ This Message was edited by: strav100 on 2004-11-13 08:54 ]</font>
IRQ config for scope pro - which PCI slot do I use ?
-
sonicstrav
- Posts: 459
- Joined: Wed Jan 28, 2004 4:00 pm
