the fiberoptic inputs on the back of the pulsar

ronaldmeij · Post by **ronaldmeij** » Wed Oct 10, 2001 11:03 am

guys maby iam wrong but it is possible to connect a cd player with spdif fiberoptic to the fiberoptic i/o of the back of the pulsar

what device need i to load in to the system ?

subhuman · Post by **subhuman** » Wed Oct 10, 2001 1:40 pm

As of Pulsar V3, it is now possible to use the ADAT port as a switchable Optical SPDIF!

I believe you do this in the "Sample Rate Settings" dialog box, switch to Optical SPDIF, then the signal is duplicated from SPDIF Coax output, also to the first ADAT ports.

algorhythm · Post by **algorhythm** » Wed Oct 10, 2001 2:07 pm

is it "either/or"? (no, not kierkagaard).
I mean can I use one as spdif and the other as ADAT? I suspect not . . .

ronaldmeij · Post by **ronaldmeij** » Wed Oct 10, 2001 2:33 pm

but can i record a digital cd player by optical in the adat a-input

then i open device sp dif input ( and there my signal from the cd player ??)

because i did that but i have no signal...

its a pulsar 2

subhuman · Post by **subhuman** » Wed Oct 10, 2001 2:36 pm

Check your Master/Slave settings.

ronaldmeij · Post by **ronaldmeij** » Wed Oct 10, 2001 3:34 pm

dubhuman can u try it your self and see if it works because i cant get it running i checked everything , new cables and even the manual !!!!

its not working overhere

once again what i did "

sony cd player optical out

in the adat a optical in

set in the samplerate window to optical

open the device spdif in and patch it to my analog outputs.

But there is no sound going into the system ,
i hate it ,if i cant get it running....

So if u could check it , i know if iam doing it wrong or there is a buggie

Thankz in advance !

Ronald Meij.

ronaldmeij · Post by **ronaldmeij** » Wed Oct 10, 2001 3:35 pm

sorrie iam ttping in a dark studio

its SUBHUMAN...........

emenelton · Post by **emenelton** » Wed Oct 10, 2001 5:19 pm

in the adat a optical in
open the device spdif in
-make sure you're using the 'new' optical spdif module-
and patch it to my analog outputs.
-ok-
set in the samplerate window to optical
-set sample rate to slave and choose correct input to slave to, with your cd on and connected with the correct module you will see the sample-rate appear as 44.1 in the sample-rate window, if you choose other inputs that have nothing connected to them while in the slave mode the sample-rate setting will switch to blank-