Page 1 of 1
Posted: Mon Jul 14, 2003 4:15 pm
by jboeke
Why oh why - if Iload XTCproject.pro and exit SFP - doesn't logic want to start up anymore? I really need to work in XTC mode!
Thanks
Jasper
<font size=-1>[ This Message was edited by: jboeke on 2003-07-14 17:58 ]</font>
Posted: Mon Jul 14, 2003 4:26 pm
by siberiansun
did you properly edit your xtcproject.pro?
try replacing your current .pro with this one:
http://www.planetz.com/forums/viewtopic ... forum=14&0
i use that one myself.
good luck!
Posted: Wed Jul 23, 2003 5:56 am
by zelimir
hi jboeke
I cannot get XTC plugins either, although everything is prepared and done as i should be.
I gave up. Actually, working in SFP is much easier and "logical", you directly see what is connected where, you can combine synths, ASIO, wave devices, external analog inputs, huge gallery of effects to the same mixer.
Logis I use for sequencing ASIO software synths FM7, B4, PRO-52, then my MIDI keyboards, and finaly Creamware synthesizers.
I am 100% satisfied with this kind of setup.
Posted: Wed Jul 23, 2003 7:33 am
by jboeke
Hi Zelimir
I know it makes the most sense to do so, but I sometimes miss automation control of CW effects, wich is a great feature of Logic I find.
I've heard in the meantime that installing an older version of SFP and then upgrade it is the only way.
Cheers
<font size=-1>[ This Message was edited by: jboeke on 2003-07-23 08:34 ]</font>
Posted: Wed Jul 23, 2003 11:16 am
by garyb
actually,the cw plugs need to be in logic's vstplugins folder and xtc must be enabled in the settings window of sfp.from there it should work.if not,then reinstall sfp over the old installation making sure that when the window askimg where to put xtc -plugs comes up that the vstplugins folder is specified.(it should be automatic)
Posted: Fri Jul 25, 2003 6:26 am
by Zer
You didn`t forget to close the pulsar app int the task panel, did you ??
Posted: Fri Dec 05, 2003 3:58 pm
by felix o.
for having xtc plug ins available you have to install first sfp driver only, second install logic and third install sfp software with xtc mode enabled.