Page 1 of 1
Posted: Thu Jul 03, 2003 2:48 pm
by Music Manic
When I attatch A16 Z-Link to Pulsar mixer,I get about -70dB noise level for each channel which adds up to a lot of noise.Is this due to equipment added to it or is it self noise?
Thx!
Posted: Thu Jul 03, 2003 8:09 pm
by Music Manic
It's ok
Manual said this would happen.
Posted: Fri Jul 04, 2003 5:28 pm
by Herr Voigt
Take the gates, for each channel one. My synths make a noise around -78 dB and I gated them. So no noise will accumulate.
Gate only uses low DSP.
Posted: Fri Jul 04, 2003 5:40 pm
by aMo
The only problem with gate's, is that if not properly set up, you can risk cutting the beginnings and/or ends of sounds with a long attack/release time...
Posted: Fri Jul 04, 2003 9:50 pm
by Music Manic
Just trying -10dB switch on A16 to give better S/N ratio.