Page 1 of 1
Posted: Tue Jul 01, 2003 4:36 pm
by enb141
Hi,
When I hook my External CDRW into any USB port (USB 1.1 or 2.0) it crashes my SFP 3.1c, how I can fix it?
My setup:
Windows XP SP1, DX9a
GigaStudio 2.54
Cubase SX 1.06
Luna II
Sony 32/10/40 with CD-509-U2 External Enclosure
Posted: Tue Jul 01, 2003 5:27 pm
by aMo
Your Creamware card is probably sharing IRQ with a USB controller, moove the card to a slot where it does not share any irq, og change irq in the bios if you can..
My system also crashes if i have my pulsar in an irq sharing position with usb, especially if I transfer some samples or something over usb...
No irq sharing, no problem
<font size=-1>[ This Message was edited by: aMo on 2003-07-01 18:28 ]</font>
Posted: Thu Jul 03, 2003 12:45 pm
by enb141
I did it but I have it in the IRQ 22 and nothing else is there, I also tryed to change the IRQ in the BIOS (motherboard Intel D850MV) but it didn't change the IRQ that I selected in the bios.
Posted: Mon Jul 07, 2003 7:46 am
by Zer
is your system already set up for ACPi ? Use the standard-pc mode.
Posted: Mon Jul 07, 2003 7:46 am
by Zer
and by the way If I were you I`d deinstall dx 9.0a .
Type dxdiag at the run prompt of your system to see what I mean.
<font size=-1>[ This Message was edited by: Zer on 2003-07-07 08:47 ]</font>
Posted: Mon Jul 07, 2003 2:48 pm
by enb141
Yes, it's on ACPI but I don't know how to disable it.
As I know Direct X can't be uninstalled so why do you recommend me to uninstall it?