Page 1 of 1
Posted: Sat Jun 28, 2003 11:32 pm
by Music Manic
When 0dBFS is reached on the mixer what is the voltage value reference of the analogue output.I keep getting 0dBu on my outboard mixer.Shouldn't it be about +24dBu? if I'm not mistaken.
Could someone decipher that please.
Thx!
Posted: Sun Jun 29, 2003 6:56 am
by kimgr
What i/o card or convertor are you using ?
Balanced or Unbalanced ?
What mixer ? Which inputs ?
Kim.
Posted: Sun Jun 29, 2003 9:16 am
by Music Manic
I'm using analogue out of Pulsar I/II,which are unbalanced going into Yamaha Promix01 mixer
Thx
Posted: Sun Jun 29, 2003 9:17 am
by Music Manic
Sorry,stereo in also.
Posted: Mon Jun 30, 2003 12:12 am
by kimgr
OK, you're running unbalanced->unbalanced.
So according to the Luna/2496 specifications the nominal output level is -10 dB, and the maximum output level is 0 dB. (I don't have the specifications on "classic" i/o plate, but I assume they're the same.)
Compare that to the balanced connections on A16 Ultra:
Nominal output level + 4 dB
Maximum output level + 20 dB
Kim.
Posted: Mon Jun 30, 2003 9:46 am
by Music Manic
Where can I get the balanced plate from for the PulsarII
thx
Posted: Mon Jun 30, 2003 12:13 pm
by garyb
your dealer.
Posted: Mon Jun 30, 2003 1:02 pm
by dehuszar
I'm told that these days, you have to send the card back in to get the I/O plate replaced. Apparently they are issues that can arise if you slap on the wrong one (I guess they were updated at some point).
Though take this with a grain of salt as I heard this from the same person who told me that multiple STD/M cables didn't affect the amount of internal connections you can make.
Damn if I can remember who it was who told me that. Anyway, I'd call the Tech Support staff and get the straight dope.
Sam
Posted: Mon Jun 30, 2003 1:57 pm
by Music Manic
Thx guys
Phoned dealer today and he said that they don't have them in stock but was going to phone creamware.