PlanetZ forums - scopeusers.com

Hi
has any one tried to update to SX 1.06? I have just tried and it did not recognise my scope asio drivers. I tried to roll back to SX 1.051 and it did not recognise my dongle. I have uninstalled and installed SX1.03 and it does not recognise the dongle either... Maybe my dongle is now faulty?
I hate SX...
Regards
Kenf
JUST IGNORE ME I had forgotten to switch my ADAT source on and I have creamware set to sync to it. I love SX again.

<font size=-1>[ This Message was edited by: Kenf on 2003-06-20 10:48 ]</font>

... but i hate sx... from the start

On 2003-06-20 10:24, Kenf wrote:

I hate SX...

JUST IGNORE ME I had forgotten to switch my ADAT source on and I have creamware set to sync to it. I love SX again.

Obvious is not always obvious

I can't wait until my computers are really smarter than me (shouldn't be THAT hard) so I can focus on music and it can focus on making everything work!

-Mythalethe

will the machine find fulfillment in being your slave at that point?
more importantly,will it be WILLING to be your slave when it is your mental superior?...

Ofcourse! It will see how much good it is doing as a higher being!

Thanks for the advise.
And as i can read on Cubase forum, a lot of trouble with 1.06.........better wait!

Hi arela
I would go for 1.06. I have used it for a few weeks and it is at least as stable as 1.03 with a few fixes.
Regards
Kenf

I agree,
I installed 1.06 with no probs and it has never been a problem. Just remember to save the download first and not as automatic install, i.e. download from ftp site. Then install with any virus software turned off.
All the best