Page 1 of 1
Posted: Wed May 28, 2003 8:07 am
by bosone
i have just installed a pulsar SRB, for a total of 11 dsp (pulsar1+luna+pulsar SRB)
when i load a lot of things, although i have a lot of free dsp power (in dsp meter window) i sometimes receive a message of dsp error because there are no more stdm connections between board X and Y (where X,Y=0,1,2).
any ideas???
Posted: Wed May 28, 2003 9:48 am
by Music Manic
Had same problem.Just clean and reload windows for fresh start.
Posted: Wed May 28, 2003 12:59 pm
by rodos1979
Hello!
I cant suggest anything. The only thing I can say is that I used to have a Pulsar 1, a Pulsar 2 and a Pulsar XTC and I have never had managed to make the three of them work together without unexpected dsp loads and and no more stdm connections messages and stuff like that! I think for most people, the maximum you can go is with 2 creamware cards in the same PC. With 3, you are likely to encounter problems.
However, try to clean with alcohol the stdm cables and make sure everything is well connected. It can make wonders sometimes!!!
Thank you!
Posted: Wed May 28, 2003 6:51 pm
by garyb
clean the contacts with 95% or purer alchohol.(don't touch with your fingers)i have 3 pulsar1 cards(1pulsar1 and 2 srbs)working fine.