Page 1 of 1
Posted: Sat May 24, 2003 4:28 pm
by Steve-o
Anybody knows how to get it to work WITHOUT using Multi FX S (cause settings will not be stored with song) ??
Help appreciated!
Cheers, Steve-o
Posted: Sat May 24, 2003 10:39 pm
by garyb
does it exist in the vst folder of your sequencer?
Posted: Sun May 25, 2003 12:33 pm
by Steve-o
I put it in there - but there's only *.dev's available after install of Vinco - no dlls. So Vinco is not available from VSTplugins in SX. Hm...
Posted: Mon May 26, 2003 6:09 am
by siberiansun
sounds strange since both spl attacker and optimaster works in xtc mode....
did you try the old worn out solution; remove all vinco files from vstplugins folder, reinstall?
Posted: Mon May 26, 2003 9:52 am
by Steve-o
Yes, Sib, I tried-no success. Attacker has dlls in XTC-folder under VSTPLUGINS. Do you use Vinco in XTC-mode? Anybody?
Posted: Mon May 26, 2003 4:13 pm
by garyb
how about manually copying the .dlls into the vst folder?
Posted: Mon May 26, 2003 10:04 pm
by mano
i have vinco working in xtc mode HOWEVER sometimes it acts a bit weird (it looks like it is off or it disappears!)
Posted: Wed May 28, 2003 12:04 pm
by Steve-o
On 2003-05-26 17:13, garyb wrote:
how about manually copying the .dlls into the vst folder?
SURE - but there aren't any dlls after installation the OXE of Vinco - nowhere!
Strange...
Did you do that?
Steve
<font size=-1>[ This Message was edited by: Steve-o on 2003-05-28 13:05 ]</font>
Posted: Wed May 28, 2003 6:48 pm
by garyb
afaik the dlls are in the sfp installation.you might try reinstalling to make sure that they go in the right folder.i believe you can copy them off the install disk if you want to do it manually.to my knowledge the oxe only authorizes the use of vinco.......
Posted: Fri May 30, 2003 9:56 am
by lookmoo
I can use Vinco S & Vinco M on Cubase SX by
1)copy 2 files ( Vinco S.dev & Vinco M.dev ) to C:SFPDevicesXTC
2) copy some dll files ( i use GRAPHEQ S.dll ) from Cdrom (SFP 3.1c PC ) to youe XTC ( C:Program FilesSteinbergVstPluginsXTCGRAPHEQ S.dll )
3) rename GRAPHEQ S.dll to Vinco S.dll & Vinco M.dll you must make it 2 times for have Vinco S.dll & Vinco M.dll in C:Program FilesSteinbergVstPluginsXTC
4) try to test it on Cubase SX & use it
happy happy happy
Posted: Wed Jun 18, 2003 5:20 am
by Steve-o
Hi lookmoo: can't believe this. I just returned from a 2 week vacancy with my notebook and long awaited Nuendo 2 and couldn't answer earlier.
I'll try out your tip tonite and will report...
Greets and thanks for your help!
Steve
Posted: Wed Jun 18, 2003 3:37 pm
by Steve-o
Do not understand how, but it works!
Great, thank you for your help! Steve