PlanetZ forums - scopeusers.com

Hello dear fellow pulsarians.
I'm getting a bit tired of the "Xtc plugins are not available...." dialogue box that appears everytime i start logic.
i do believe i read somewhere that it's possible to remove it but obviously i don't remember where...

thankful for any help on this, cheers!

I think if you go into setup and disable XTC plugins (a little check box) that'll do the trick. I never use XTC myself, and no longer get that little message.

Hope that helps,

Wil.

this message is because you have sfp running when you start the program.
you need to shut down sfp in order to use xtc mode.....(

this message is because you have sfp running when you start the program.
you need to shut down sfp in order to use xtc mode.....(

i'm one inch right now from saying:
"well.......DUH!"
But i won't

Thanks!