Page 1 of 1
Posted: Tue May 06, 2003 4:05 am
by FrancisHarmany
Hi,
When I load limiters/compressor into insert slots of mixers/multifx sidechaining does work but values of input channels (for sidechain) will not be saved with the project. Also, I cant change the values when I set them. I cant disconnect either, clicking the "none" option does nothing.
Solutions ? Known problem ?
Peace,
---F.
Posted: Tue May 06, 2003 9:20 am
by at0m
-> Input channels (for sidechain) will not be saved with the project.
That is right, the plugins don't remember their SC input. :/ I wrote to
SFPreport@creamware.com for that.
-> Also, I cant change the values when I set them. I cant disconnect either, clicking the "none" option does nothing.
Try reselecting the selected SC input, will de-select it. You can then assign new SC inputs.
Posted: Wed May 07, 2003 5:37 am
by FrancisHarmany
Great, that works!
I will bug
SFPreport@creamware.com as well! I suggest everybody who reads this thread those
If they wont listen we'll start sending screenshots of each non-remembered sidechain input, fullscreen ofcourse *grin*
Or you could just breath on them atomic!
Posted: Wed May 07, 2003 1:33 pm
by risan
Hi fransh,
The only work-around I know for this issue is to have your compressor or limiter external of the mixer. The project will remember the routing that way. Hope this helps.
Nasir
Posted: Mon Jun 30, 2003 10:37 am
by spiderman
about gate as insert fx it seems the sidechaine works only on stereo channel . On mono channel nothing can be selected ... someone to comfirm that ?
Posted: Fri Oct 22, 2004 10:26 pm
by wayne
bump - i was about to post a new topic when i noticed spiderman's observation.
it is true - limiter m, gate m and expander m have unselectable sidechain inputs.