Page 1 of 1
Posted: Sun May 04, 2003 4:16 am
by flashvalley
Lately I'm getting this error message quite a lot: "Unexpected DSP overload"
Never had this before and doesn't cause any real problems but I'd prefer it didn't happen. Does anyone have a clue what could be the cause of this?
thanx!
Posted: Sun May 04, 2003 9:39 am
by flashvalley
Just wanted to add that this error message occurs even when I'm not using SFP.
Posted: Sun May 04, 2003 10:55 am
by at0m
You are getting "unexpected dsp overload" when sfp (and it's taskbar icon) are not running?
Posted: Sun May 04, 2003 2:33 pm
by astroman
is the temperature inside your case ok ?
Heat is a good candidate for strange messages.
cheers, Tom
Posted: Mon May 05, 2003 9:41 am
by flashvalley
SFP is running in the taskbar, but nothing is loaded or running within the program..
I'll have to check the temp but I think it is quite stable.
Posted: Tue May 06, 2003 8:54 am
by virtualstudio
after running very stabile for about a year, I suddenly have the same problem you have, I have 3X PulsarII, . Last week I put an extra cooler this seems to work .!!
I didn't see thee error message again . so I think astroman is right!!
good luck
TERRANOVA-AMSTERDAM
Posted: Tue May 13, 2003 10:20 am
by flashvalley
Quite often the error appears shortly after I've started my computer. So I doubt if the temp inside my case is causing this error..
Strange...
Posted: Wed May 14, 2003 6:01 am
by rodos1979
Hello!
I had a similar problem. I am running 2 Pulsar cards. Astroman, suggested me to have a look and see if they are properly seated. When I openned the PC I found out that the STDM cable was not seating very well. I cleaned evrything with alcohol, connected evrything well again and now all is smooth like butter!
So, especially if you run multiple cards, I would suggest that you see if the STDM cable is sitting well...if not, check that the card itself is seating well.
Thank you and good luck