Page 1 of 1

Posted: Mon Jun 18, 2001 12:42 pm
by huicholity
Hi,
As we are talking about switch, i have a little problem with the 'exclusive Switch' . With one is ok (and useful!) but when i use the 'link' pad, it doesn't link at all...
I tried to connect the 2 'link' together or on one of the switch button but nothing link at all...
Does it work with your ScopeDP ?
best regards,
<Huicholity>
http://www.huicholity.com

Posted: Mon Jun 18, 2001 1:00 pm
by Neutron
Doesnt that link have something to do with the switch setup? why dont you just connect both switches to the same button?

i am not at my SCOPE right now i will have a look tonight. (yes it is running again)

Posted: Fri Jun 22, 2001 10:46 am
by spacef
Hui,

there's an example that use a linked excl switch. don't remeber exactly which example though. but i don't think there's an example of link to 2 modules ?

<font size=-1>[ This Message was edited by: spacef on 2001-06-22 12:21 ]</font>