PlanetZ forums - scopeusers.com

Hi all,

Today I finally got me a VC-8 breakout box and started to install it.

I followed the Pulsar manual and connected the ASIO Source module to the ADAT A Dest module. When I wanted to start playing some VST instruments (Cubase SX) I only got signal on the left channel. When I look into the VST output box I am able to select the 4 busses and I also see the VU meter's left/right output, however I see that in the pull down menu I can only select adat a 1, adat a 3, adat a 5, etc.

Does this have to do with the VC-8 or is there just a mono signal coming out of the Pulsar card?

Any suggestions?

Cheers,

Acid

i own the VC8 and i observe no problems in in/out.
i have set my vc8 as slave and i have connected both adat cables (in and out). i don't know what could be the problem... if you connect asio dest to anaolg out do you hear both channels??
but i'm not sure i understood your problem... you go to vc8 input, and then what do you use for output? to what is connected the vc8 output?