PlanetZ forums - scopeusers.com

Posted: **Tue Feb 11, 2003 4:59 am**

Hi all!
I've tried to install a PulsarII Card + XTC Card on a ASUS P4B533 +1Giga DDr Ram + P4 2.4Giga and a ATI RADEON 128 AGP 4x.

I've re-installed the system from scratch ( deleting the previous NT partition + formatting ), then installed the drivers, then the SFP 3.01 and then XTC sw. I go into Cubase Sx and I can see only ASIO MME e ASIO DX!

The system worked perfectly on Win2K, what am I supposed to do?

Thks in advance for any kind answer!

Posted: **Tue Feb 11, 2003 5:13 am**

did you use some regcleaner?! regcleaner (with bundle icone) can erase asio.

Posted: **Tue Feb 11, 2003 8:00 am**

Hi!
I didn't install that sw but how can I know if it's already installed?

Thks for any kind answer, I'm simply desperado!

Posted: **Tue Feb 11, 2003 8:12 am**

this sw isn't instaled with windows. also you must run them to erase asio. so, this is some other problem.
i don't know much about xtc.
are you sure that you have regular xtc project with asio in background?!

Posted: **Tue Feb 11, 2003 9:18 am**

Here's a previous discussion about this problem with some useful suggestions:

http://www.planetz.com/forums/viewtopic ... 33&forum=1

Posted: **Tue Feb 11, 2003 3:20 pm**

I was getting that error because Pulsar was having trouble slaving to a faulty external ADAT. A quick diagnostic is to set Pulsar as samplerate master and see if you get your ASIO back.

-mythalethe

Posted: **Tue Feb 11, 2003 6:04 pm**

Why don't you try to reïnstall the creamware drivers, then Cubase SX and then SFP?

PlanetZ forums - scopeusers.com

No ASIO in Win XP with a PulsarII Card + XTC Card