Page 1 of 1
Posted: Mon Feb 03, 2003 5:26 pm
by moosejaw
I recently installed a Pulsar II card with Cubase SL. When I bring up the default Pulsar Project and then start Cubase SL I get a rythmic (about once per sec) clicking sound that is coming from the ASIO source Left and can be seen in the mixer channel that it is routed to. There is nothing coming from ASIO source Right. This happens even before a load a Cubase Project. Messing around and rebooting it has gone away a couple times but then comes back. Any thoughts?
Posted: Thu Feb 13, 2003 9:30 am
by sharcsound
Try removing all the modules in the Pulsar Projet window one at a time, and replace them with new modules. This fixed a problem I had continually with one mixer when I removed it and re-inserted it again.
Posted: Thu Feb 13, 2003 9:31 am
by sharcsound
Try removing all the modules in the Pulsar Project window one at a time, and replace them with new modules. This fixed a problem I had continually with one mixer when I removed it and re-inserted it again.
Posted: Fri Feb 14, 2003 3:47 pm
by giucant
Have you got a pIV?
In that case you should consider denormalization problem issue....
Read more and find solution:
http://www.digitalfishphones.com/main.p ... &subItem=6